Identifying Damaged Consumables in a Plasma Cutting System: Part 1

MIG Guns Air-Cooled vs Water-Cooled

Over time and with constant use, the components and consumables of a plasma cutting system naturally wear out. This results in reduced quality and precision of the produced parts. Important signs that indicate a consumable requires change is when you notice an increase in the bevel edge, edge distortions and build-up of dross at the bottom. When such problems crops up, many times the operator replaces all the consumables such as the shield cap, electrode and nozzle instead of individual components. This results in superfluous usage of consumables and increases the overall operation cost. The production cost of each finished part also increases significantly.

The torch consumables’ life are affected by many variables and it is a better option to learn to identify what is wrong with any consumable by inspecting it visually when the cut quality drops. Not only must the nozzle, shield cap and electrode be inspected, it is important to examine the swirl ring and the inner as well as the outer retaining caps also for any defects. We go into the depths of how you can identify damaged consumables at the earliest in this two part series. We kick off part one of this series with an eye on some of the key consumables.

The Outer Retaining Cap

The outer retaining cap is a brass cap that keeps all the components together onto the head of the torch. The outer cap should be replaced only if there is any damage such as burns or dents on either of the openings, slag build up, or if you face any difficulty in threading the cap onto the torch head.

The Inner Retaining Cap

The inner retaining cap has a body made of copper with an insulator ring that is placed on it. This helps in installing the inner retaining cap into the shield cap. The function of the inner retaining cap is to ensure that the coolant is circulated outside the nozzle and to ensure that the gas is distributed through the tiny holes that are present in the insulator ring to the shield cap. This component is not exposed to the plasma arc and can withstand use up to at least thirty electrode replacements.

You must replace the inner retaining cap only if the aperture is bent, burnt, out of shape, or the minute holes in the insulator ring or copper body are blocked.

The Shield Cap

The shield cap funnels the shielding gas and is used for additional nozzle cooling and improved cut edge. Though the shield cap is not exposed to the plasma arc, because it is very close to the workpiece, it is prone to damage from torch pierces and crashes that are made near the plate.

The orifice in the shield cap is critical to the edge cut quality and when the shield cap becomes bent, burnt or out of shape, it must be replaced. If there is any slag or splatter build-up on the shield cap, it can be removed by using an abrasive hand pad. Care must be taken not to use sandpaper to remove the slag.

The O-rings must be inspected regularly for any cracks, tears, nicks and the O-rings must be lubricated properly.

This sums up part one of the two part series. We’ve covered the need to replace consumables in a timely manner and some of the consumables you should keep a close eye on for wear and tear in this part. Catch the concluding second part of this series on our blog soon!

Leave a Reply

Your email address will not be published. Required fields are marked *